|
3-3-8-proverka-pozicionnogo-pereklyuchatelya-rychaga-pereklyucheniya-peredach-af13-ii.html
3.3.8. Check of the position switch of the lever of gear shifting (AF13-II)
Dismantle the holder of the socket of a plait of wires 2.
Unfasten the socket of a plait of wires of the position switch of the lever of gear shifting 1.
Disconnect the socket of a plait of wires of the position switch of the lever of gear shifting.
Install KM-962-A 3 devices with KM-962-10.
Connect to the socket of a plait of wires of the position switch of the lever of gear shifting.
Connect to the accumulator.
Check work and setup of the position switch of the lever of gear shifting.
Include ignition.
Make switching on all transfers.
|
NOTE
For each transfer the light-emitting diodes corresponding to marks in the sliding table (in the drawing check in position of the N lever is shown) have to light up.
|
At work violation
Adjust hummock system of the drive of gear shifting.
Adjust the position switch of the lever of gear shifting.
Check work of an electric part of the position switch of the lever of gear shifting
Dismantle KM-962-A devices with KM-962-10.
Disconnect from the socket of a plait of wires of the position switch of the lever of gear shifting 1.
Disconnect from the accumulator.
Switch off ignition.
Build in the holder of the socket of a plait of wires 2.
Tighten the holder of the socket of a plait of wires – 20 N · m.
Attach and fix the socket of a plait of wires of the position switch of the lever of gear shifting.
| 