Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
2.1. Petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.2. Mechanical part of petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.3. Cooling system
2.4. Lubrication system
2.5. System of injection
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Test and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.10.1. Removal and installation of fuel nozzles
2.10.2. Replacement of a fuel-supply line of high pressure (The pump of high pressure – the pressure chamber)
2.10.3. Module of the fuel pump
2.10.4. Replacement of the module of a dosage
2.10.5. Replacement of the regulator of pressure of fuel
2.10.6. Replacement of damping fuel return case
2.10.7. Replacement of the fuel level sensor
2.10.8. Fuel tank
2.10.9. Replacement of a tube of a jellied mouth of the fuel tank (petrol engines)
2.10.10. System of catching of vapors of fuel
2.10.11. Replacement of a forward ventilating tube
2.10.12. Removal and installation of container with absorbent carbon
2.10.13. Removal and installation of the sensor of a mass consumption of air
2.10.14. System of release (Z 14 XEP, Z 14 XEL, Z 16 XEP)
2.10.15. System of release (Z18 XE)
2.11. Lubrication system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 





0653563c

2-10-6-zamena-dempfiruyushhego-korpusa-vozvrata-topliva.html

2.10.6. Replacement of damping fuel return case

Removal
Open a cowl.
Disconnect the rechargeable battery.
Disconnect the grounding connector from a grounding clip.
Uncover the engine.
Remove the damping fuel return case.
Remove the return fuel-supply line from the special KM-796-A tool.
Remove 2 hoses.
Remove 2 collars.
Disconnect an oil pipeline.
Turn off 2 bolts (arrows in the drawing).

NOTE
If the oil pipeline is disconnected from the damping case, then it has to be replaced by new.

Remove 4 oil pipelines.
Remove 4 collars (arrows in the drawing)

Installation
Establish an oil pipeline.
Connect 4 oil pipelines to fuel nozzles.
Attach the damping fuel return case.
Attach an oil pipeline.
Attach the return fuel-supply line.
Attach 2 hoses.
Establish 2 collars.
Tighten 2 bolts the moment of 9 N · m.
Establish an engine cover.
Connect the rechargeable battery.
Attach the grounding connector to a grounding clip.
Program volatile memory.
Close a cowl.

"on the page back
2.10.5. Replacement of the regulator of pressure of fuel
on the following page"
2.10.7. Replacement of the fuel level sensor