Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
2.1. Petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.2. Mechanical part of petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.3. Cooling system
2.3.1. To fill filling of the cooling system and removal of air (Z10XE, Z10XEP)
2.3.2. Replacement of the sensor of temperature of cooling liquid (Z10XE, Z10XEP, without conditioner)
2.3.3. Removal and installation of the pump of cooling liquid (Z10XE, Z10XEP, with the conditioner)
2.3.4. Removal and installation of the thermostat with a branch pipe of cooling liquid (Z10XE, Z10XEP, without conditioner)
2.3.5. Replacement of a radiator (Z10XE, Z10XEP, with the conditioner)
2.4. Lubrication system
2.5. System of injection
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Test and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Lubrication system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 















0653563c

2-3-4-snyatie-i-montazh-termostata-s-patrubkom-okhlazhdayushhejj-zhidkosti.html

2.3.4. Removal and installation of the thermostat with a branch pipe of cooling liquid (Z10XE, Z10XEP, without conditioner)

Removal
Open a cowl.
Merge cooling liquid.

NOTE
On option of the ECO model uncover motor office below.

Substitute the reception pallet.
Open a carving stopper of a drain opening (shooter).
Above 2 disconnect a radiator hose from a branch pipe of cooling liquid.
Release a collar.
Dismantle a branch pipe of cooling liquid 1.
Turn off 3 bolts of fastening.
Installation
When replacing details consider various options of a design. You watch correctness of numbers of details.
Clean the sealing surfaces of the pump of cooling liquid, a branch pipe of cooling liquid.
Establish a branch pipe of cooling liquid.
Replace consolidation.
Tighten 3 bolts of fastening the moment of 8 N · m.
Establish a radiator hose above.
Fix a collar.
Close a carving stopper of a drain opening of cooling liquid.
To fill the cooling system and remove from it air.

NOTE
On option of the ECO model establish a cover of motor office below.

Close a cowl.

"on the page back
2.3.3. Removal and installation of the pump of cooling liquid (Z10XE, Z10XEP, with the conditioner)
on the following page"
2.3.5. Replacement of a radiator (Z10XE, Z10XEP, with the conditioner)