Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
2.1. Petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.2. Mechanical part of petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.3. Cooling system
2.3.1. To fill filling of the cooling system and removal of air (Z10XE, Z10XEP)
2.3.2. Replacement of the sensor of temperature of cooling liquid (Z10XE, Z10XEP, without conditioner)
2.3.3. Removal and installation of the pump of cooling liquid (Z10XE, Z10XEP, with the conditioner)
2.3.4. Removal and installation of the thermostat with a branch pipe of cooling liquid (Z10XE, Z10XEP, without conditioner)
2.3.5. Replacement of a radiator (Z10XE, Z10XEP, with the conditioner)
2.4. Lubrication system
2.5. System of injection
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Test and repair operations of components of a mechanical part of the engine
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Lubrication system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 















0653563c

2-3-1-zapolnenie-sistemy-okhlazhdeniya-zapolnit-i-udalenie-vozdukha-z10xe-z10xep.html

2.3.1. To fill filling of the cooling system and removal of air (Z10XE, Z10XEP)

Check and survey
Antifreeze is intended not only for protection of all cooling system against freezing, but also for protection of all details washed by liquid for cooling from corrosion / lime application. Therefore even in the conditions of tropics it is impossible to refuse antifreeze addition.
An important role along with composition of fuel mix is played also by quality of water. Drinking water, as a rule, conforms to these requirements. The regenerated sea water in a qualitative sense is insufficient.
Damages of the engine can arise also from the antifreezes which are not allowed to use.
After replacement of a radiator, a head of cylinders or consolidation of a head of cylinders the reused cooling liquid cannot be used.
Open the cooling system.
Turn off a cover of a compensation tank of cooling liquid.
Fill in cooling liquid in a compensation tank of cooling liquid to the mark "KALT/COLD".
Wrap a cover of a compensation tank of cooling liquid.
Start the engine idling, the thermostat will not open yet.

NOTE
Air quits the cooling system during a stage of warming up of the engine.

Stop the engine, let's it cool down.
Check the level of cooling liquid in a compensation tank of cooling liquid and if necessary add to necessary level.

"on the page back
2.3. Cooling system
on the following page"
2.3.2. Replacement of the sensor of temperature of cooling liquid (Z10XE, Z10XEP, without conditioner)