Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
4.1. General information
4.2. Wheels and tires
4.3. Running gear
4.4. Forward suspension bracket
4.5. Back suspension bracket
4.5.1. Check of an angular gap of knot of the wheel bearing
4.5.2. Removal and installation of the back bridge
4.5.3. Removal and installation of the stabilizer
4.5.4. Removal and installation of the back shock-absorber
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 















0653563c

4-5-3-snyatie-i-ustanovka-stabilizatora.html

4.5.3. Removal and installation of the stabilizer

Removal
Remove 2 back wheels.

NOTE
Mark the provision of rather drum nave.

Turn out 2 screws of 1 fastening of the stabilizer on the back bridge.

NOTE
You watch ustanovkany position of fixing screws.

Remove the stabilizer 3 from the back bridge.
Wring out from the back bridge a mandrel from soft metal 2 the stabilizer on the one hand.
Remove from the back bridge and remove the stabilizer through lateral face.
Remove the buffer 4 from the stabilizer.

Installation
Install the stabilizer 3 on the back bridge.
Push sideways the stabilizer to the back bridge.
Push the buffer 4 on the stabilizer.
Press the stabilizer a mandrel from soft metal 2 to ustanovkany situation in the back bridge.
Install the stabilizer with 2 screws and a nut 1 on the back bridge.

NOTE
You watch ustanovkany position of fixing screws. Screws are installed from below up on the back bridge.

Tighten 2 new screws 1 moment of 60 N · m + 15 °.
Establish 2 back wheels – 110 N · to m.

NOTE
Observe the provision of marking.

"on the page back
4.5.2. Removal and installation of the back bridge
on the following page"
4.5.4. Removal and installation of the back shock-absorber