Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
2.1. Petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.2. Mechanical part of petrol Z10XE, Z10XEP, Z12XE, Z12XEP DOHC-I engines
2.3. Cooling system
2.4. Lubrication system
2.5. System of injection
2.6. Petrol engines – the general procedures of check
2.7. Mechanical part of the engine
2.8. Test and repair operations of components of a mechanical part of the engine
2.8.1. Check of a gap in the conrod bearing
2.8.2. Check of a gap in the conrod bearing
2.8.3. Replacement of the conrod bearing
2.8.4. Replacement of piston rings
2.8.5. Replacement of the piston with a rod
2.9. Cooling system
2.10. System of injection of fuel of petrol engines
2.11. Lubrication system
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 





0653563c

2-8-3-zamena-shatunnogo-podshipnika.html

2.8.3. Replacement of the conrod bearing

Remove the oil pallet.
Note an order of covers of conrod bearings.
Disconnect covers of conrod bearings from rods.

NOTE
The surfaces of contact of rods and covers of conrod bearings are selected individually and therefore them it is impossible to rearrange or allow their damages. to avoid damage, do not put rods and covers on the surfaces of contact.
Pay attention to adjusting situation – inflows (shooter) on covers of conrod bearings have to be turned towards the transmission.

Turn off 8 bolts of fastening.
Clear all knots, check and replace in case of need.
Establish new inserts of conrod bearings and cover them with engine oil.
Attach covers of conrod bearings to rods.
Tighten 8 bolts of fastening the moment of 13 N · m also tighten on +60 ° and +15 °.
Use new bolts.

ATTENTION
Always use bolts of M6,5.
"on the page back
2.8.2. Check of a gap in the conrod bearing		 on the following page"
2.8.4. Replacement of piston rings