Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
1.1. Description of the car
1.2. Keys, locks of doors, the opening body elements
1.3. Governing bodies, combination of devices, light and sound alarm system
1.4. Seats
1.5. System of passive safety
1.6. Heating and air conditioning
1.6.1. A heating system and ventilation with the additional conditioner
1.6.2. Climate control
1.6.3. Conditioner
1.6.4. Heating of seats
1.6.5. Inclusion signaling devices in keys
1.6.6. Management of climate control
1.6.7. Air inlet
1.7. Driving and service of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 





0653563c

1-6-5-signalizatory-vklyucheniya-v-klavishakh.html

1.6.5. Inclusion signaling devices in keys

Having blown
Install temperature regulator in the necessary situation.
Include having blown, establish the necessary degree of an obduv.
For the maximum ventilation of the top space: install the air distributor on, all nozzles are open.
For ventilation of the lower space of salon: install the air distributor on.
For simultaneous ventilation of the top and lower space: install the air distributor on.

Heating
Power of heating depends on temperature of cooling liquid and therefore reaches the maximum value only at the heated-up engine.
For bystry warming up of salon turn temperature regulator to the red sector, include a step of an obduv 3, install the air distributor in desirable situation.
Convenience, good health and comfort of passengers substantially depend on the correct installation of the mode of ventilation and heating.
To reach distribution of temperature by the principle "the head in cold, and legs in heat", install the rotary regulator of distribution of air in situation, or, install the temperature switch on desirable temperature.

Heating of the lower space
For heating of the lower space turn temperature regulator to the red sector, include having blown and install the air distributor on.

Removal of moisture and hoarfrost from glasses

ATTENTION
Non-compliance with the specified rules can lead to fogging of glasses and accidents as a result of deterioration in visibility.

Turn temperature regulator against the stop in the red sector.
Establish having blown on 3 or 4.
Install the air distributor on.
Include heating of back glass.
On requirement direct side nozzles of an obduv to side glasses.
For simultaneous heating of the lower space install the air distributor in situation.

Air conditioning mode
Switch off the air circulation mode.
Establish desirable extent of cooling.
Install temperature regulator in the necessary situation.
Include having blown, to adjust an air consumption.
Install the air distributor in situation or.
Open nozzles on requirement.
If temperature switch on average range: warmer air comes to the lower space, and colder – up, warm air comes out from side snuffled an obduva, and colder – from averages.

Maximum cooling
For a short time open windows and a sliding roof quicker to remove heated-up air.
Include the air circulation mode
Include cooling.
Turn temperature regulator against the stop in the blue sector (more cold).
Establish having blown on 4.
Install the air distributor regulator in situation.
Open all nozzles.

Removal of moisture from glasses
To eliminate fogging of glasses, for example, or from damp clothes include cooling in wet weather.
Install temperature regulator in the necessary situation.
Include having blown, to adjust an air consumption.
Install the air distributor on, the system of air circulation will be switched off automatically if after work of system at the previous mode in it there is a moisture, glasses can mist over. For prevention of it it is necessary to establish before launch of the engine distribution of air in situation, and approximately through 5 from later start-up – in situation.
Include heating of back glass.
Non-compliance with the specified rules can lead to fogging of glasses and accidents as a result of deterioration in visibility.

Removal of hoarfrost from glasses
Switch off cooling.
In install temperature regulator in the necessary situation.
Adjust on requirement having blown.
Install the air distributor on, the system of air circulation will be switched off automatically.
Open side nozzles of an obduv.
Include heating of back glass.
The mode with cooling (the cooling compressor) at a low external temperature does not join.

"on the page back
1.6.4. Heating of seats
on the following page"
1.6.6. Management of climate control