Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. System of power supply
7.2. System of lighting
7.2.1. Check and adjustment of headlights, external lighting, lamp of salon, switch of headlights
7.2.2. Adjustment of fog lights
7.2.3. Removal and installation of headlights
7.2.4. Removal and installation of back fog lights
7.2.5. Replacement of the glow lamp of driving beam
7.2.6. Replacement of the glow lamp of passing beam
7.2.7. Replacement of the glow lamp of xenon headlights
7.2.8. amine of the glow lamp of the index of turn (xenon headlight)
7.2.9. Removal and installation of a starter of a xenon lamp
7.2.10. Replacement of a lamp of driving beam / lamp of parking fires (xenon headlight)
7.2.11. Replacement of the glow lamp / lighting lamp of a luggage carrier or luggage compartment
7.2.12. Removal and installation of illumination of registration plate / glow lamp
7.2.13. Removal and installation of the switch of a control lamp of the parking brake
7.2.14. Replacement of the forward lamp of salons / glow lamps
7.2.15. Removal and installation of the back lamp of the salon / glow lamp
7.2.16. Removal and installation of the lighter / glow lamp
7.3. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 















0653563c

7-2-4-snyatie-i-montazh-zadnikh-protivotumannykh-far.html

7.2.4. Removal and installation of back fog lights

Removal
Dismantle a protective covering of a back wheel niche, unscrew a plastic nut of fastening 1.
Unscrew the Torx 3 screw.
Remove a protective covering 3.
Dismantle back fog lights.
Unblock and disconnect the socket of a plait of wires of 2 back fog lights.
Turn off the screw 1.
Remove back fog lights.
Remount or replace the glow lamp.
Turn off the glow lamp with the boss 3 and remove.
Unscrew and remove the glow lamp.

Installation
Establish back fog lights.
Insert back fog lights.
Tighten the screw.
Connect and fix the socket of a plait of wires of back fog lights.
Carry out an inspection of work of lamps.
Establish a protective covering of a back wheel niche.
Insert a protective covering, tighten a plastic nut of fastening.
Tighten the Torx screw.

"on the page back
7.2.3. Removal and installation of headlights
on the following page"
7.2.5. Replacement of the glow lamp of driving beam