Repair of Opel Corsa C, from 2000 to 2005 release.
1. Operation and maintenance of the car
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. General procedures of check
6.2.1. Check and adjustment of elements of the brake system
6.2.2. Check of level of brake fluid in a tank of a hydraulic actuator of the working brake system
6.2.3. Removal of air from a hydraulic actuator of the working brake system
6.2.4. Brake hoses
6.3. Operations of adjustment and replacement of elements of the brake system
6.4. Anti-blocking system (ABS 8.0 and ABS 8.0 ESP)
7. Onboard electric equipment
8. Body
9. Schemes of electric equipment
 





0653563c

6-2-4-tormoznye-shlangi.html

6.2.4. Brake hoses

Brake hoses carry out mobile communications between mobile and motionless parts of the car.
It is necessary to check hoses of the brake system at least two times a year.
For the prevention of sudden failure of the brake system carefully check a condition of all pipelines and connections, paying special attention to the following:
Metal pipelines should not have забоин, scratches, zadir, the active centers of corrosion and have to be located far from sharp edges which can damage them.
The brake hose has to be elastic, not have anguishes and cracks. The hose has to be closed strongly up in tips. The carving of tips of a hose should not have damages. If when pressing a brake pedal the hose is inflated, so threads of cords are torn. At detection of any of these defects the hose needs to be replaced. On hoses the mineral oils and lubricants dissolving rubber should not get.
All brackets of fastening of pipelines have to be whole and are well fixed. Weakening of fastening or destruction of brackets leads to vibration of pipelines which causes their breakages.
Leak of brake fluid from connections of the main cylinder with pipelines and a tank is not allowed.
At detection of malfunctions replace the damaged details new. Irrespective of their state, replace flexible hoses new after 120 thousand km of a run or after five years of operation of the car to warn sudden gaps because of rubber aging. The brake hose rubbing against a suspension bracket detail wears out and finally fails.
For check use a mirror and illumination.

"on the page back
6.2.3. Removal of air from a hydraulic actuator of the working brake system
on the following page"
6.3. Operations of adjustment and replacement of elements of the brake system